Brief Introduction
MRac Ground Terrace V (GTV), is specially developed for middle-to-large ground PV projects developed based on GT4. Due to its high structural strength and stability, GT V can freely adapt to areas with heavy snow and wind load. The GTV can also slightly adjust on site on anchor plates to avoid the error when driving the piles or embeding the bolts. The adjust range are: 0~20m horizontally and vertically. The GT V has no front support which is suitable for lower ground clearance and will save the cost and improve installationeffiency. The pre-assemble structural designs save more time and labor cost as well.
Technical Parameter
Installation Site: | Ground |
Foundation | Concrete bases, Ground screws |
Installation Angle | 5-60° |
Wind Load | 80m/s |
Snow Load | 1.6KN/m2 |
PV Modules | Framed, unframed |
Module Orientation | Portrait and landscape |
Standards | AS/NZS 1170 |
DIN 1055 | |
JIS C 8955:2011 | |
International Building Code IBC 2009 | |
California Building Code CBC 2010 | |
Profile Materials | Al6005-T5(Anodized) |
Fasten Parts | SUS304 |
Small Components | Al6005-T5(Anodized) |
Color | Silvery or according to customer requirements |
Warranty | 10 years |
Advantages
GT V is fully pre-assmbled due to simplified structure, which will further reduce installation time.
The adjustable anchor plates help to adjust the position of supports , especially when installed on concrete columns or ground screws;
The square tubes are conductive to improve the stability.
The beams can be well installed without drilling or cutting.
If combiner boxes, inverters or back side supports are needed to be fastened to GT V, they will be installed directly on supports by T bolts without drilling on site;
Product Structure Diagram
Components List
![]() | ![]() | ![]() | ![]() |
Wide End Clamp Kit | U27 Inter Clamp Kit | C Clamp Kit | Beam |
![]() | ![]() | ![]() | ![]() |
Beam Splice Kit | Pre-assembled GT5 Support | T Anchor Plate | T Corrugated Anchor Plate |
Installation Guide
Fasten Corrugated T Anchor Plates and T Anchor Plates onto embedded bolts on concrete bases;
Fasten the T Jointer on the front of GT5 Pre-Assembled Supports to the T Anchor Plates; and fasten the Back Supports and the Inclined Support to the Corrugated T Anchor Plate;
Repeat the above steps;
Install Beams;
Install Back Side Support;
Installation of Solar Panels;
The installation is complete.
Reference Projects
Workshop
Carbon steel factory owns 15 steel rolling production lines, and 4 solar stent aluminum production lines.
Installation Guide
MRac Ground Terrace V Installation Guide.pdf